Martin-christ Beta 2-8 LDplus User Manual download pdf (Page 14)

14  General Information Operating Manual Freeze Dryer BETA 1-8 LDplus / BETA 2-8 LDplus

1.6.2. CAUTION! Solvents!

Acidic products or products with a high solvent

concentration cannot be dried without special protective measures

and devices such as e.g. a cooling trap for protection of the

vacuum pump (if necessary check with our service department).

Besides, the unit may be damaged by corrosion.

Special caution is necessary when using azides because a

dangerous explosive develops in combination with copper or non-

ferrous metals! It is absolutely essential to consult our service

department!

1.6.3. ADVICE! Cleaning and Maintenance of the Unit!

For infectious, toxic, pathogenic and radioactive

substances the corresponding safety regulations must be

observed.

1.6.4. WARNING! Freezing of Limbs to Surfaces!

During operation of the freeze-dryer dangerous

situations in the ice condenser chamber may arise. When putting

in the shelves take care that limbs do not come into contact with

the condenser in the ice condenser chamber as the limbs may

become frozen to the surface. The limb can only be detached from

the surface by applying heat. Liquid should not be used.

1.6.5. ADVICE! Transport Instructions!

Please keep the packaging for possible subsequent dispatch.

The freeze-dryer should be carried by two persons by holding it

underneath on both sides.

WARNING! When transporting or putting down the unit do not hold

the plastic control panel. Please note: When putting the unit down

on a surface there is a danger of squeezing hands or fingers.

WRONG

CORRECT

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 88 89

No comments

Martin-christ Beta 2-8 LDplus User Manual Page 14